Technics SX-F100 Owner's Manual page 93

Part
Ill
Sequencer
Playback
lrom
a specific measure
You can specify the measure from which you wish playback to begin .
1. Press the SEQUENCER button to turn it on .
2. Select PLAY on the display.
• The display looks similar to the following .
SEQUENCER PLAY
~EJ
MEASURE
:
jRESETIJ~
HEASURE
T !ME SIG. = 4/4
~G
MEMORY
=
99 %
[]E[J]~
~~BALjj
J
=
120
PLAY PLAY
MM~~ldilfi§il~~
~~mHJ[H)!ill][H]faiD[21)
3. Select the tracks you wish to have played
back .
4. Use the MEASURE
1\
and v buttons to specify
the beg inning measure of playback.
• "MEASURE=" indicates the current measure
number.
• You can quick-search for the desired measure
while listening to the recorded performance by
holding down the FWD button . (This button
does not work during normal playback.)
• You can press the RESET button to return to
the beginning of the first measure and recall
the panel status which was in eHect at the
beginning of recording . (This button does not
work during playback.)
• If you wish to adjust the volume of each track,
press the SAL button to recall the PART
BALANCE display. You can then adjust the
volumes.
91
5. Press the START/STOP button .
• The recorded performance is played back from
the specified measure .
• When playback is begun from a measure in
which an INTRO , COUNT INTRO, FILL IN or
ENDING is recorded, the corresponding func-
tion does not work .
6. To stop playback, press the START/STOP but-
ton again.
• If the START/STOP button is pressed again,
playback will continue from the point it was
interrupted .