Technics SX-F100 Owner's Manual page 161

Phenomenon Remedy
Storage is not possible. • The remaining memory capacity of the SEQUENCER is
0. Follow the SONG CLEAR or TRACK CLEAR procedure
to erase the memory. (Refer to pages 82 and 83.)
Multi-track storage is not possible.
• The playback
track
has been selected, but the
0::
START/STOP button has not been pressed. A flashing
UJ
track indicator shows the track which is ready for recording,
(.)
z
and a lit track indicator shows a track which is ready for
UJ
playback. To record one track while listening to another
::J
0
(playback) track, press the
START/STOP
button to begin
UJ
playback. (Refer to page 73.)
(/)
The playback measure indication is different from • The number of measures corresponds to the time signature
when the performance was recorded. of the rhythm selected at the start of recording . To change
the rhythm in the middle of the song, record the rhythm
change in the RHYTHM part. (Refer to page 78.)
0
No sound is produced for the automatic accompani- • In the RHYTHM GROUP section, a rhythm in COMPOSER
0::
ment. A or COMPOSER B with no stored pattern was selected.
0
J:
Select a different rhythm.
(.)
>- No sound is produced for the automatic accom- • Some or all of the ACCOMP 1, 2 and 3 buttons are turned
~
paniment, or only the sounds of some parts are off. Press the buttons to turn them on.
...J
Cl.
produced.
0
~
:;)
~
Storage is not possible. • The remaining memory capacity of the
COMPOSER
is 0.
Setting the time signature and number of measures • The time signature and number of measures cannot be
is not possible.
changed for a pattern which is currently recorded in the
a:
COMPOSER .
If you wish to change the time signature
UJ
(/) and/or measure data, first follow the procedure to clear
0
Cl.
the memory. (Refer to page 97 .)
:2:
0
The playback timing of the rhythm pattern is different
• The QUANTIZE function was on when the pattern was
(.)
from the liming with which it was recorded .
recorded and the timing was automatically corrected . Set
the quantize level to a smaller note unit or to OFF when
recording. (Refer to page 99.)
The Disk Drive produces a noise during recording or
• This occurs when the Disk Drive is reading a disk. It does
~
playback.
not indicate a problem.
>
...
When the procedure to load from a disk is performed, • When performing the load operation from a disk, the
0
the contents of the keyboard memory are erased.
keyboard memory changes to that of the data loaded from
.:.:
en
the disk . If you wish to preserve a song which is stored in
0
the keyboard memory , save it on a disk before performing
the load procedure . (Refer to page 107 .)
Noise from a radio or TV can be heard .
• This sometimes occurs when electrical equipment such as
a rad io or TV is used near the instrument. Try moving such
electrical equipment further away from the instrument .
....
• The sound may be coming from a nearby broadcast station
Q)
.c
or amateur radio station. If the sound is bothersome,
0
consult your dealer or service center.
The cabinet becomes warm during use.
• This instrument has a bu ilt-in power source that heats the
cabinet to some degree . Th is is not an indication of trouble .
159