Technics SX-F100 Owner's Manual page 155

r
Part IX
SYSTEM EXCLUSIVE BULK DUMP
This instrument's internal data such as panel set-
tings , performance data, etc. can be transmitted
to an received from another SX-F1 00 Organ or
other MIDI equipment as SYSTEM EXCLUSIVE
data .
• Sound is not generated from this instrument
during this procedure .
SYSTEM EXCLUSIUE BULK DUMP
~I
TOTAL ORGAN
~I
COHPOSE~
lsEtmll~
~I
SEQUENCER
~I
SOUND HEHORY
~I
PANEL HEHORY
GENERAL MIDI
Make the GENERAL MIDI settings . (A brief ex-
planation of GENERAL MIDI is on page 143.)
GENERAL 11 ID I
GENERAL
11101 HODE OFF
Warning
• The SEQUENCER memory is cleared when
the GENERAL MIDI mode is changed .
• If the power is turned off while the
GENERAL MIDI mode is ON, the setting is
automatically set to OFF and the SEQUEN-
CER memory is cleared.
153
MIDI
11
Transmit1ing
1. Follow the procedure necessary to prepare the
receiving instrument for data reception .
2 . Use the buttons to the left of the display to
select the type of data to transmit (TOTAL
ORGAN, COMPOSER , SEQUENCER,
SOUND MEMORY or PANEL MEMORY) .
3 . Press the SEND button.
• During transm ission, the transmitting status is
shown on the display .
• Receiving
After accessing this display on this instrument,
follow the transmission procedure on the trans-
mission side.
• During reception , the receiving status is shown
on the display .
1.
Use the ON and OFF buttons to specify
whether or not this instrument should be com-
patible with GENERAL MIDI standard instru-
ments.
• This setting is automatically set to ON if data
is loaded from a disk for which the GM mode
was set to on, or from a disk for which the GM
mode has not been specified.
• If ON is selected, the status of this instrument
changes to the GENERAL MIDI status, and
the sounds and operations which can be
selected are limited . In addition, the arrange-
ment of percussion sounds on the keyboard
changes. (Refer to the separate "REFER-
ENCE GUIDE" provided.)
• If GENERAL MIDI on/off data is received from
connected MIDI equipment, the received data
has priority .
2. Press the OK button .
• The confirmation display appears . Press the
YES button to execute the function , or press
the NO button to cancel the function .