Technics SX-F100 Owner's Manual page 92

Part Ill
• AUTO PUNCH RECORD
You can set the punch-in and punch-out points
beforehand , so that recording automatically
begins and ends at the specified points .
1. On the SEQUENCER menu display , select
PUNCH RECORD, and then select the track
which conta ins the portion you want to correct .
2. Press the AUTO PUNCH button.
• The display looks similar to the following .
AUTO PUHCH RECORD
CURRENT MEASURE :JB
PUNCH OUT MEASURE
MEASURE COUNT IH
Press the START/STOP button to begin
3 . Select PUNCH IN MEASURE. Use the MEAS
1\
and
v
buttons to specify the number of the
punch-in measure .
4 . Select PUNCH OUT MEASURE . Use the
MEAS
1\
and
v
buttons to specify the number
of the punch-out measure.
• The number of the PUNCH OUT MEASURE
must be higher than the number of the PUNCH
IN MEASURE.
• The specified PUNCH OUT MEASURE is not
recorded .
5. Select MEASURE COUNT IN. Use the MEAS
1\
and
v
buttons to specify the number of
lead-in measures you wish to have played
back before the punch-in measure.
• Playback will begin from the measure indi·
cated by CURRENT MEASURE on the dis-
play .
• Set the metronome to on or off with the ON
or OFF button .
90
Sequencer
6. Press the START/STOP button .
• Playback beg ins from the measure specified
in step 5.
7. Correct the performance .
• The mode changes automatically to the
recording mode at the specified punch-in
measure . Begin play ing at th is point. The
mode automatically changes back to the
playback mode at the specified punch-out
measure.
• Note that , even when you have set the punch·
in and punch-out measures, you can begin
recording before the punch-i n measure starts
by play ing the keyboard or pressing a foot
switch to which the PUNCH IN/OUT function
has been assigned .
8. When you have finished correcting the per-
formance , press the SEQUENCER REC but-
ton to turn it off.
- - - - - -
--
- - - - ---
~--