Adding Rear Weight - Toro 04530 Operator's Manual

9. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 13), push the suspension arm
down so that the bar fits over the bar across the top
of the cutting unit (Figure 14).
1
1. Latch—closed position
2. Suspension-arm bar
1. Suspension-arm bar
10. Close the latches down and around the cutting-unit
bar and lock them in place (Figure 13).
Note: A "click" can be heard and felt when the
latches are properly locked in place.
11. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 15).
12. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both
sides of the motor (Figure 15).
2
Figure 13
3. Latch—open position
Figure 14
2. Cutting-unit bar
3
g014609
1. Reel motor
2. Spline shaft
13. Mount a grass basket onto the basket hooks on the
suspension arm.
14. Repeat this procedure for the other cutting units.
15. Connect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 22).
8

Adding Rear Weight

Parts needed for this procedure:
1 Weight kit, 119-7129 (for two-wheel drive units)
Weight kit, 120-5750 (for units with the 3-wheel drive
1
kit installed)
Procedure
This unit complies with the ANSI B71.4-2004 and EN
836 Standards when equipped with weight kit 119-7129
(2-wheel drive units) or 120-5750 (3-wheel drive units).
18
Figure 15
3. Cavity
4. Motor retaining bar