6
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6
Grass-basket hook
12
Flange bolts
Procedure
Install the 6 grass-basket hooks onto the ends of the
suspension-arm bars using the 12 flange bolts
8).
1. Flange bolt
2. Grass-basket hook
7
Installing the Cutting Units
Parts needed for this procedure:
1
Gauge bar
3
Cutting unit (obtain from your Toro Distributor)
3
Grass basket
Procedure
1.
Setup the cutting units as described in the
cutting unit Operator's Manual.
Figure 8
3. Suspension-arm bar
2.
Apply grease to the inside diameter of the drive
coupler.
3.
Install the cutting units as described in
the Cutting Units (page
8
Adding Rear Weight
Parts needed for this procedure:
Weight Kit, Part No. 121-6665 (purchase separately)
1
Note: This kit is not required for units with the 3 wheel
drive kit installed.
(Figure
Procedure
This unit complies with EN ISO 5395:2013 and ANSI
B71.4-2017 when equipped with Weight Kit, Part No.
121-6665.
Note:
If the unit is equipped with a 3-Wheel Drive
Kit, additional weight is not required to meet EN ISO
5395:2013 and ANSI B71.4-2017.
9
Installing EU Decals
g015492
Parts needed for this procedure:
1
Warning decal (Part No. 133-2339)
Procedure
If this machine will be used in the EU, affix the warning
decal 133-2339 over English warning decal 133-2338.
13
Installing
40).