Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04530 Operator's Manual

CAUTION
If you do not disconnect the power to the cutting
units, someone could accidentally start the cutting
unit, causing serious injury to hands and feet.
Always separate the cutting unit power disconnect
couplers before working on the cutting units.

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Weight

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
59.5 inches (151 cm)
50.5 inches (128 cm)
46.9 inches (119 cm)
98.0 inches (249 cm)
70.62 inches (179 cm)
80.83 inches (205 cm)
Refer to the traction unit
serial tag (Figure 1).
23

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions
and symbols in the safety section. Knowing this
information could help you or bystanders avoid injury.
The use of protective equipment, such as but not
limited to, for eyes, ears, feet, and head is recommended.
CAUTION
This machine produces sound levels in excess of
85dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.

Checking the Engine Oil

The engine is shipped with 1-3/4 quarts (1.65 liters)
(w/filter) of oil in the crankcase; however, the oil level
must be checked before and after the engine is first
started.
The engine uses any high-quality detergent oil having
the American Petroleum Institute (API) service
classification of SG, SH, or SJ or higher. The
recommended viscosity (weight) is SAE 30.
1. Position the machine on a level surface.
2. Unscrew the dipstick and wipe it with a clean rag.
Screw the dipstick into the tube and make sure it is
seated fully (Figure 27).