Transport Operation; Inspection And Cleanup After Mowing; Towing The Traction Unit - Toro 04530 Operator's Manual

increasing the load on the engine, hydraulic system,
brakes, etc.

Transport Operation

Make sure the cutting units are in the full up position.
Move the functional control lever to the transport
position. Use the traction pedal to slow the machine
while going down steep hills to avoid loss of control.
Always approach rough areas at a reduced speed and
cross severe undulations carefully. Familiarize yourself
with the width of the machine. Do not attempt to pass
between objects that are close together so that costly
damage and down time can be prevented.
Inspection and Cleanup After
Mowing
At the completion of the mowing operation, thoroughly
wash the machine with a garden hose without a nozzle
so excessive water pressure will not cause contamination
and damage to the seals and bearings. After cleaning,
inspect the machine for possible hydraulic fluid
leaks, damage or wear to hydraulic and mechanical
components, and the cutting units for sharpness.
Also, lubricate the mow and lift pedal and brake shaft
assembly with SAE 30 oil or spray lubricant to deter
corrosion and help keep the machine performing
satisfactorily during the next mowing operation.

Towing the Traction Unit

In case of an emergency the machine can be towed for
a short distance (less than 1/4 mile (0.4 km)). However,
Toro does not recommend this as standard procedure.
Important: Do not tow the machine faster than
2-3 MPH (3-5 km/h) because the drive system
may be damaged. If the machine must be moved
a considerable distance, transport it on a truck or
trailer.
1. Locate the bypass valve on the pump and rotate it
so that the slot is vertical (Figure 41 ).
1. Bypass valve-slot shown in closed (horizontal) position
2. Before starting the engine, close the bypass valve by
rotating it so that the slot is horizontal (Figure 41).
Do not start the engine when the valve is open.
33
Figure 41
1
g014627