Marking The Outer Grass Baskets; Adding Rear Ballast And Weight; Kit - Toro Greensmaster 3120 Operator's Manual

5
Marking the Outer Grass
Baskets
No Parts Required
Procedure
To assist in aligning the machine for successive
cutting passes, do the following procedure to the No.
2 and No. 3 cutting unit baskets:
1. Measure in approximately 12.7 cm (5 inches)
from the outer edge of each basket.
2. Either place a strip of white tape or paint a line
onto each basket paralleling the outer edge of
each basket (Figure
1. Alignment strip
2. Approximately 12.7 cm (5
inches)
11).
Figure 11
3. Cut grass on right
4. Keep focal spot 1.8 to 3
m (6 to 10 ft) ahead of the
machine.
6
Adding Rear Ballast and
Weight Kit
Parts needed for this procedure:
Rear Weight Kit (Part No. 100-6441)—purchase
1
separately
19.5 kg (43 lb) of calcium chloride (purchase
1
separately)
Procedure
This machine complies with the ANSI B71.4-2017.
Standard when you equip it with the Rear Weight
Kit (Part No. 100-6441) and add 19.5 kg (43 lb) of
calcium chloride ballast to the rear wheel.
Important:
If a puncture occurs in a tire with
calcium chloride, remove the machine from the
turf area as quickly as possible. To prevent
possible damage to the turf, immediately soak the
affected area with water.
g005115
13