Installing The Optional Oil Cooler; Installing The Grass Basket Hooks; Installing The Cutting Units - Toro 04530 Operator's Manual

WARNING
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can cause
the battery gasses to explode, resulting in personal
injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
5
Installing the Optional Oil
Cooler
No Parts Required
Procedure
If you are operating the machine in hot climates, where
the ambient temperature is above 85 degrees F (29
degrees C), or using it for heavy-duty use (mowing other
than greens, such as fairways or verticutting), install a
Hydraulic Oil Cooler Kit, Part No. 119-1691, to the
machine.
6
Installing the Grass Basket
Hooks
Parts needed for this procedure:
6 Grass basket hook
12 Flange bolts
Procedure
Install the 6 grass basket hooks onto the ends of the
suspension arm bars using 12 flange bolts (Figure 9).
1. Flange bolt
2. Grass basket hook
7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
3 Cutting unit (model 04613, 04614, or 04615)
3 Cutting unit upper weight
6 Hex socket-head screws
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result.
Important: Whenever the cutting unit has to be
tipped to expose bedknife/reel, prop up rear of
cutting unit to make sure nuts on back end of
bedbar adjusting screws are not resting on work
surface (Figure 10).
16
Figure 9
3. Suspension arm bar