4. Locate the open connector on the main wire harness
to the right of the seat and connect it to the wire
harness that came with the seat.
5. Route the seat wire harness around the seat slides,
ensuring that it will not be pinched when the seat
moves, and connect it to the port on the bottom of
the seat.
3
Installing the Steering Wheel
Parts needed for this procedure:
1
Steering wheel
1
Locknut (1-1/2 inches)
1
Washer
1
Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure 5).
g014687
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft (Figure 5).
3. Secure the steering wheel to the shaft with a jam
nut and tighten it to 20 to 26 ft-lb (27 to 35 N-m)
(Figure 5).
4. Install the cap to the steering wheel and secure it
with a screw (Figure 5).
4
3
2
1
Figure 5
3. Jam nut
4. Cap
4
Activating and Charging the
Battery
No Parts Required
Procedure
Use only electrolyte (1.265 Specific Gravity) to fill
battery initially.
1. Remove the fasteners and battery clamp and lift out
the battery.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent
caps (Figure 6).
1. Vent caps
3. Carefully fill each cell with electrolyte until the plates
are covered with about 1/4 inch (6 mm) of fluid
(Figure 7).
14
Figure 6