Installing And Removing The Cutting Units - Toro 04530 Operator's Manual

that the interlock system is operating correctly.
Correct the problem if it is not operating properly.
3. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral,
and engage the parking brake. Start the engine
and move the functional control lever to mow or
transport. The engine should kill, which means that
the interlock system is operating correctly. Correct
the problem if it is not operating properly.
4. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral, and
engage the parking brake. Start the engine. Release
the parking brake, move the functional control
lever to mow, and rise from the seat. The engine
should kill, which means that the interlock system
is operating correctly. Correct the problem if it is
not operating properly.
5. Sit on the seat, move the traction pedal to Neutral,
move the functional control lever to Neutral, and
engage the parking brake. Start the engine. Move
the raise/lower mow control forward to lower the
cutting units. The cutting units should not start
rotating. If they do, the interlock system is not
operating correctly. Correct the problem.
Installing and Removing the
Cutting Units
Installing the Cutting Units
1. Disconnect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 22).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally start
the cutting unit, causing serious injury to hands
and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position (Figure 31).
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
3. Position the cutting unit under the center suspension
arm.
4. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 32), push the suspension arm
down so that the bar fits over the bar across the top
of the cutting unit (Figure 33).
1. Latch—closed position
2. Suspension-arm bar
28
2
Figure 31
2. Footrest—open
1
2
Figure 32
3. Latch—open position
g014602
3
g014609