Setup; Install The Steering Wheel(Tc Models Only); Install Rops(Tc Models Only) - Toro workman HDX-D 07368 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Parts Manual
Operator Training Material
Note: Determine the left and right side of the machine
from the normal operating position.
1
Install the Steering Wheel
(TC Models Only)
Parts needed for this procedure:
1 Steering wheel
1 Cap
1 Washer
Procedure
1. Remove the nut from the steering shaft. Slide the
steering wheel, and washer onto the steering shaft
(Figure 3).
2. Secure the steering wheel to the shaft with the nut
and tighten it to 20-25 ft-lb (27–34 N-m).
3. Install the cap on the steering wheel.
Description
Steering wheel
Cap
Washer
ROPS frame
Bolt, 1/2 inch
Electrolyte
No parts required
Qty.
1
1
1
1
6
A/R
–
Qty.
1 Read before operating the vehicle
1 Use to reference part numbers
1 View before operating machine
1. Steering wheel
2. Jam nut
13
Use
Install the steering wheel.
Mount the ROPS (Rollover Protection
System)
Activate and charge the battery.
Check the engine oil, transaxle/hydraulic
fluid, and brake fluid levels
Use
Figure 3
3. Cap
4. Washer