Table of Contents
Advertisement
5
Connecting the CVT-Intake
Duct
No Parts Required
Procedure
Important:
Remove the plastic bag covering the
end of the CVT duct before starting the engine.
The CVT Kit (Part No. 121-9853) and Adapter Kit
(Part No. 127-8750) are required for this procedure.
1.
Loosen the hose clamp securing the plastic bag
at the end of the CVT-intake hose and remove
the bag.
2.
Raise the cargo bed by performing the following:
A.
Engage the parking brake.
B.
Start the engine.
C.
Move the hydraulic-lift lever rearward to
raise the cargo box.
D.
Shut off the engine.
E.
Remove the bed support from the storage
brackets on the back of the ROPS panel
and install the support onto the cylinder rod
of the bed-lift cylinder; refer to
Bed Support (page
3.
Align the CVT-intake hose onto the intake-tube
connector at the back side of the ROPS panel
and tighten the hose clamp
1. CVT-intake hose
2. Hose clamp
Using the
33).
(Figure
7).
Figure 7
3. Intake-tube connector
4.
Remove the bed support, lower the bed, shut off
the engine, and remove the key.
6
Burnishing the Brakes
No Parts Required
Procedure
To ensure optimum performance of the brake system,
burnish the brakes before use.
1.
Bring the machine up to full speed, apply the
brakes to rapidly stop the machine without
locking up the tires.
2.
Repeat this procedure 10 times, waiting 1 minute
between stops, to avoid overheating the brakes.
Important:
if the machine is loaded with 454 kg (1,000
lb).
g026251
13
This procedure is most effective
Advertisement
Table of Contents
