Provisioning File Transfer - Polycom SoundPoint IP 300 Administrator's Manual

Administrator's Guide - SoundPoint
Parameter
subnet mask
IP gateway
boot server address
SIP server address
SNTP server address
SNTP GMT offset
DNS server IP address
alternate DNS server IP
address
DNS domain
VLAN ID
a. For more information on DHCP options, go to http://www.ietf.org/rfc/rfc2132.txt?num-
b. This value is configurable.
c. Note that the configuration file value can be configured to override the DHCP value. Refer
d. Note that the configuration file value can be configured to override the DHCP value. Refer
e. This value can be obtained from a connected Ethernet switch if the switch supports CDP.

2.2.1.2 Provisioning File Transfer

The SIP application performs the provisioning functions of downloading configura-
tion files, uploading and downloading the configuration override file and user direc-
tory, and downloading the dictionary and uploading log files.
The protocol that will be used to transfer files from the boot server depends on several
factors including the phone model and whether the bootROM or SIP application stage
of provisioning is in progress. TFTP and FTP are supported by all SoundPoint
SoundStation
SoundStation
6
®
IP / SoundStation
DHCP Option
Refer to
2.2.1.3.2
DHCP Menu
on page 9
42 then 4
Refer to
2.2.1.3.2
DHCP Menu
on page 9
ber=2132.
to tcpIpApp.sntp.address.overrideDHCP in section 4.6.1.10.2 Time Synchronization
<SNTP/> on page 121.
to tcpIpApp.sntp.gmtOffset.overrideDHCP in section 4.6.1.10.2 Time Synchronization
<SNTP/> on page 121.
®
phones. The SoundPoint
®
IP 4000 bootROM also supports HTTP, while the SIP application sup-
Copyright © 2006 Polycom, Inc.
®
IP
Configuration File
a
DHCP (Phase 2: application only)
1 •
3 •
•
•
b
151
•
2 •
6 •
6 •
15 •
Special Case: Cisco Discovery Protocol (CDP)
rides Local FLASH that overrides DHCP VLAN Dis-
®
IP 301, 430,
Installation and Operation
Local
FLASH
-
-
-
-
c
•
d
•
-
-
-
covery.
501, 600 and 601 and
•
•
•
•
•
•
•
•
•
e
over-
®
and