Polycom SoundPoint IP 300 Administrator's Manual page 17

Administrator's Guide - SoundPoint
Name
IP Gateway
Server Menu
SNTP Address
GMT Offset
DNS Server
DNS Alternate Server
DNS Domain
Ethernet
b
EM Power
a. A parameter value of "???" indicates that the parameter has not yet been set and saved in the
phone's configuration. Any such parameter should have its value set before continuing.
b. Only available on SoundPoint
The DHCP and Server sub-menus may be accessed from the main setup menu.
2.2.1.3.2 DHCP Menu
The DHCP menu is accessible only when the DHCP client is enabled. DHCP configu-
ration parameters are described in the following table:
Name
Timeout
® ®
IP / SoundStation IP
a
Possible Values
dotted-decimal IP
address
dotted-decimal IP
address
OR
domain name string
-13 through +12
dotted-decimal IP
address
dotted-decimal IP
address
domain name string
Enabled, Disabled
®
IP 601 phones.
Possible
Values Description
1 through 600 Number of seconds the phone waits for secondary
DHCP Offer messages before selecting an offer.
Copyright © 2006 Polycom, Inc.
Installation and Operation
Description
Phone's default router.
Refer to 2.2.1.3.3 Server Menu on page 11.
Simple Network Time Protocol (SNTP) server
from which the phone will obtain the current
time.
Offset of the local time zone from Greenwich
Mean Time (GMT) in half hour increments.
Primary server to which the phone directs
Domain Name System (DNS) queries.
Secondary server to which the phone directs
Domain Name System queries.
Phone's DNS domain.
Refer to 2.2.1.3.4 Ethernet Menu on page 12.
This parameter is relevant if the phone gets
Power over Ethernet (PoE). If enabled, the
phone will set power requirements in CDP to
12W so that up to three Expansion Modules
(EM) can be powered. If disabled, the phone
will set power requirements in CDP to 5W
which means no Expansion Modules can be
powered (it will not work).
9