Polycom SoundPoint IP 300 Administrator's Manual page 25

Administrator's Guide - SoundPoint
Important
This feature is very powerful and should be used with caution. For example, an incorrect setting could
set the IP Address of multiple phones to the same value.
Note that some parameters may be ignored, for example if DHCP is enabled it will still override the
value set with device.net.ipAddress.
Individual parameters are checked to see whether they are in range, however, the interaction between
parameters is not checked. If a parameter is out of range, an error message will appear in the log file
and parameter will not be used.
Incorrect configuration could cause phones to get into a reboot loop. For example, server A has a con-
figuration file that specifies that server B should be used, which has a configuration file that specifies
that server A should be used.
Polycom recommends that you test the new configuration files on two phones before initializing all
phones. This should detect any errors including IP address conflicts.
Name
device.set
device.xxx.yyy.set
device.net.ipAddress
device.net.subnetMask
device.net.IPgateway
device.net.vlanId
device.net.cdpEnabled
® ®
IP / SoundStation IP
Possible Values
0 or 1
default = 0
0 or 1
default = 0
dotted-decimal IP address
dotted-decimal IP address
dotted-decimal IP address
Null, 0 to 4094
0 or 1
Copyright © 2006 Polycom, Inc.
Installation and Operation
Description
If set to 0, do not use any device.xxx.yyy fields to
set any parameters. Set this to 0 after the initial
installation.
If set to 1, use the device.xxx.yyy fields that have
device.xxx.yyy.set = 1. Set this to 1 for the initial
installation only.
If set to 0, do not use the device.xxx.yyy value.
If set to 1, use the device.xxx.yyy value.
For example, if device.net.ipAddress.set = 1, then
set the contents of the device.net.ipAddress field.
Phone's IP address.
Note: This field is not used when DHCP client is
enabled.
Phone's subnet mask.
Note: This field is not used when DHCP client is
enabled.
Phone's default router / IP gateway.
Note: This field is not used when DHCP client is
enabled.
Phone's 802.1Q VLAN identifier.
Note: Null = no VLAN tagging
If set to 1, the phone will attempt to determine its
VLAN ID through the CDP.
17