Setting Ipsec (Ip Security); Checking The Network - Toshiba E-STUDIO287CS User Manual

SETTING ITEMS (ADMIN)
1
2
Item name
ENABLE LDAP
3
ENABLE IP FILTERING
ENABLE MAC
ADDRESS FILTERING
4
Memo
• To add the LDAP directory service, you must operate using
TopAccess. For details on how to register the directory
service, refer to the TopAccess Guide "Chapter 8:
[Administration] Tab Page".
5
Note
• If the LDAP network service is disabled, you will not be able
to acquire the "From Address" from the LDAP server during
the User Authentication for Scan to E-mail for transmitting
an E-mail.

Setting IPsec (IP security)

6
When the IPsec Enabler is installed, the encrypting of
communication using the IPsec (IP Security Protocol) becomes
possible.
In IP security setting, you can perform the following operations.
• Viewing the IPsec policy name currently applied
• Enabling or disabling IPsec communication
• Flushing (resetting) IPsec session
7
Description
• ENABLE — Press this button
to use the LDAP network
server service.
• DISABLE — Press this button
to disable the LDAP network
server service.
• ENABLE — Press this button
to use IP filtering.
• DISABLE — Press this button
to disable IP filtering.
• ENABLE — Press this button
to use MAC address filtering.
• DISABLE — Press this button
to disable MAC address
filtering.
Item name
POLICY NAME
ENABLE
DISABLE
FLUSH
CONNECTIONS
FACTORY DEFAULT Press this button to reset the IPsec
Memo
• Settings required for IPsec such as entry of IPsec policies
can be performed from TopAccess. For details, refer to the
TopAccess Guide "Chapter 8: [Administration] Tab
Page".
Note
• [IPsec] is available only when the IPsec Enabler is installed.

Checking the network

Two functions are available for checking the network status:
ping and traceroute.
The ping function allows you to check the connection status
between this equipment and the servers on the network. And,
the traceroute function allows you to view and check the
network path to the desired server.
- 288 -
Description
The name of the currently applied
IPsec policy is displayed.
Press this button to enable IPsec
communication.
Press this button to disable IPsec
communication.
Press this button to manually clear
(flush) the current IPsec session and
start a new session when the key
currently used for IPsec
communication has leaked or a
security violation has occurred.
settings back to the factory defaults.
When you press this button, a
confirmation message is displayed.