Center Margin; Page Layout; Outer Margin - Toshiba E-STUDIO287CS User Manual

Option Value Alternate Value
booklet=legal lg
LG
booklet= st
statement ST
booklet=folio folio-japan
booklet=A5 a5
booklet=B5 b5
B5-JIS
b5-jis
booklet=legal13 lg13
LG13
booklet=SQ85 sq85
letter-square
booklet=16K 16k
In a job, if this value is LT, and in PDL too the data are for LT
paper size, this will result in a scaled booklet on Letter paper. In
a job, if this value is A4, and in PDL the data are for A5 paper
size, this will result in a tiled booklet on A4 paper.
When the Booklet Mode options is selected, the paper size is
automatically set to the same size as for Booklet Mode. This
function is only available for A4 and Letter paper sizes.
If the booklet mode is selected, then duplexing is also selected
automatically (sduplex). Setting duplexing separately can
override the booklet mode setting for duplexing.
Example: The command to select Letter size paper for the
booklet printing mode is "lp –o booklet=letter <filename>".
 Page Layout
The booklet mode page layout can be selected using the
following options.
Option Value Alternate Value
left2right=off OFF
Description
Select Legal size paper for
the booklet printing mode.
Select Statement size
paper for the booklet
printing mode.
Select Folio size paper for
the booklet printing mode.
Select A5 size paper for
the booklet printing mode.
Select JIS B5 size paper
for the booklet printing
mode.
Select Legal-13 size
paper for the booklet
printing mode.
Select 8.5 inch square
size paper for the booklet
printing mode.
Select 16K size paper for
the booklet printing mode.
Description
Select right to left page
layout for the booklet
printing mode.
This value decides the
layout of the pages in the
booklet.
If this value is OFF then
the layout of pages is
Right to Left as shown in
the figure below.
- 73 -
Option Value Alternate Value
left2right=on ON
If left2right=off then long edge binding is selected, otherwise if
left2right=on then short edge binding is used.
Example: The command to select left to right page layout for
the booklet printing mode is "lp -o left2right=on <filename>".
 Center Margin
The booklet mode center margin can be selected using the
following options.
Option Value Alternate Value
centermargin
=value
Example: The command to select the center margin value for
the booklet printing mode is "lp -o centermargin=value
<filename>".
 Outer Margin
The booklet mode outer margin can be selected using the
following options.
Option Value Alternate Value
outermargin
=value
Example: The command to select the outer margin value for
the booklet printing mode is "lp -o outermargin=value
<filename>".
PRINTING FROM UNIX/Linux
Description
Select left to right page
layout for the booklet
printing mode.
This is the default setting.
If the value is ON then the
layout of the pages is from
Left to Right as shown in
the figure below.
Description
Select the center margin
value for the booklet
printing mode.
This value specifies in
pixels the Center Margin
or the "Gutter". This is in
addition to the center
margin already specified
by the application. The
valid range for value is 0 -
300. Default is 0.
Description
Select the outer margin
value for the booklet
printing mode.
This value specifies in
pixels the Outer Margin or
the "Creep" per page,
which should take place
while printing a booklet.
The valid range for value
is 0 - 600. Default is 0.
1
2
3
4
5
6
7