Setting The Calibration Display Level; Setting The Calibration; Changing The Roughness Of Print - Toshiba E-STUDIO287CS User Manual

SETTING ITEMS (ADMIN)

Setting the calibration display level

You can set whether this equipment will use the calibration
1
setting set by a user or the administrator.
The relevant buttons ([CALIBRATION]) will appear under the
ADMIN menu only or under both the
USER and ADMIN menus according to this setting.
Item name
CALIBRATION • USER — Press this button to display
2
• ADMIN — Press this button to display

Setting the calibration

You can automatically calibrate the color gradation when the
shading and hue are not reproduced accurately in the images
3
scanned by this machine.
Note
• Whether to allow calibration by not only administrators but
also users, is set by DISPLAY LEVEL.

P.268 "Setting the calibration display level"
• Place LT or A4 paper (recommended paper) in the drawer
before starting the calibration. If any other paper is used,
4
calibration may not be performed properly.
• If the glass is dirty or any foreign objects are stuck to it,
calibration may not be performed properly. Keep the glass
clean.
• Do not raise the original cover or the Reversing Automatic
*1
Document Feeder , or open the front cover while the
calibration is in progress. If this does happen, calibration
cannot be finished properly.
5
• Interrupt copying is not available during the calibration.
• If the color often deviates, call your dealer.
*1 The Reversing Automatic Document Feeder is an option depending on
the model.
Memo
• For instructions on how to display the CALIBRATION
6
screen, see the following page:

P.240 "Accessing the User Menu"
1 Press the button to calibrate.
Item name
COPY
7
600 dpi PRINT
1200 dpi PRINT
Note
• The available buttons differ depending on the model.
Description
[CALIBRATION] in the ADMIN menu
as well as the USER menu
[CALIBRATION] in the ADMIN menu
Description
Press this button to calibrate for
copy jobs.
Press this button to calibrate for 600
dpi print jobs.
Press this button to calibrate for
1200 dpi print jobs.
Select the paper type and press [OK].
2
Note
• Depending on the machine settings, the screen to
select the paper type may not be displayed. In this
case, proceed to the next step.
Select the calibration settings.
3
Item name
DEFAULT
CALIBRATION
Place the printed chart face down on the
4
glass, so that the two black rectangular
marks are placed on the left side.
5 Press the [START] button on the control
panel.
The calibration begins. Do not operate the equipment
until the message "Scanning and calibrating" disappears.
Note
• If the chart is not properly placed, the message "Set
chart correctly" is displayed on the touch panel. In this
case, return to step 3 and realign the chart.

Changing the roughness of print

You can switch the line density level of images in printing.
This setting applies to print jobs with 600 dpi. Set this to color
and black printing, respectively.
Item name
HIGH Press this button to print with the normal line
density level.
LOW Press this button to print with the lower line
density level than a normal one.
Memo
• Changing the setting displays the CONFIRMATION screen
that asks you whether you want to perform calibration or
not. Select [OK] or [CANCEL] as required.
- 268 -
Description
Press this button to restore the
default calibration setting and return
to the previous screen.
Press this button to calibrate using
the printed chart. In this case,
proceed to the next step.
Description