Copier; Making A Copy - Panasonic KX-MB2085CX Operating Instructions Manual

5.1 Making a copy

MRESOLUTIONN
MCOPYN MCONTRASTN
MCOPY SIZEN MFAX AUTO ANSWERN
1
If the MCOPYN light is OFF, turn it ON by pressing
MCOPYN.
2
Set the original (page 19).
3
If necessary, change the copy size (original
document size and recording paper size), resolution
and contrast according to the type of document.
R To select the copy size, see page 33.
R To select the resolution, see page 33.
R To select the contrast, see page 33.
4
If necessary, enter the number of copies (up to 99).
5
MSTARTN
R When mode restriction (feature #154 on
page 78) is activated, enter the department
code when copying. If the department code does
not match, or the department code restricts the
copy mode, copying will be cancelled.
R The unit will start copying.
6
After you finish copying, press MSTOPN to reset the
settings you set in step 3 and 4.
Note:
R To stop copying, see page 78.
R You can change the default operation mode (feature
#463 on page 59) and the timer before returning to
the default operation mode (feature #464 on
page 59).
R If the MFAX AUTO ANSWERN light is ON, the unit can
receive faxes automatically even when in the copy
mode.
To select the copy size
1. Press MCOPY SIZEN repeatedly to select "ORIGINAL
SIZE".
2. Press MCN or MDN repeatedly to select the size of your
original document. A MSETN
3. Press MCN or MDN repeatedly to select the size of
recording paper size.
R When "#2" is selected, you can change the
recording paper size by pressing MEN repeatedly.
R The appropriate zoom rate will be set
automatically. Some copying features cannot be
used during zoom copy. See page 34 for
details.
MSETN
MCNMDNMEN MSTOPN
MSTARTN
4. MSETN
To select the resolution
1. Press MRESOLUTIONN repeatedly.
– "TEXT/PHOTO": For both text and photographs.
– "TEXT": For text only.
– "PHOTO": For photographs, shaded drawings,
etc.
2. MSETN
Note:
R You can change the default resolution (feature #461
on page 66).
To select the contrast
Adjust this setting depending on the darkness or
lightness of the document. 5 levels (low to high) are
available.
Press MCONTRASTN repeatedly. A MSETN
Note:
R You can hold the previous contrast setting (feature
#462 on page 59).

5. Copier

33