Copy Reservation - Panasonic KX-MB2085CX Operating Instructions Manual

5. Copier
4
Press MCN or MDN repeatedly to select "LONG EDGE".
A MSETN
5
Enter the desired edge width of long edge using the
dial keypad. A MSETN
6
Press MCN or MDN repeatedly to select "SHORT
EDGE". A MSETN
7
Enter the desired edge width of short edge using the
dial keypad. A MSETN
8
If necessary, enter the number of documents (up to
99). A MSTARTN
9
After you finish copying, press MSTOPN to reset this
feature.
Note:
R You can hold the previous edge setting (feature #473
on page 66).
5.2.7 Margin feature
You can set the unit not to copy a particular edge of the
document to make a margin. This is useful for binding
the copied documents.
Note:
R To automatically reduce the copies according to the
set margin, see feature #474 on page 66.
R This feature and page layout features cannot be used
at the same time.
1
Set the original (page 19).
R To make a portrait copy, set the original in portrait
direction. To make a landscape copy, set the
original in landscape direction.
2
Press MPAGE LAYOUTN repeatedly to select
"MARGIN".
3
Press MCN or MDN repeatedly to select "ON". A
MSETN
4
Press MCN or MDN repeatedly to select the page layout
from "PORTRAIT" or "LANDSCAPE". A MSETN
5
Press MCN or MDN repeatedly to select the edge you
want to set the margin for from "TOP", "RIGHT",
"LEFT" or "BOTTOM". A MSETN
6
Enter the desired margin width using the dial keypad.
A MSETN
7
If necessary, enter the number of documents (up to
99). A MSTARTN
8
After you finish copying, press MSTOPN to reset this
feature.
Note:
R You can hold the previous margin setting (feature
#475 on page 66).

5.2.8 Copy reservation

You can make a copy reservation under the following
conditions:
38
– while the unit is printing documents from your
computer.
– while the unit is printing received fax documents.
1
Set the original (page 19).
2
While "PC PRINTING" or "PRINTING" is displayed,
press MCOPYN.
3
Make necessary settings such as number of copies,
resolution, zoom features and page layout features.
A MSTARTN
R "COPY RESERVED" will be displayed. The unit
will start copying after the current printing job.