Preparing The Modem; Required Equipment - Nortel CallPilot 1002rp Hardware Installation Manual

October 2006

Preparing the modem

Introduction
You require a modem to support remote dial-up access to the CallPilot
server. The modem also enables Nortel technical support to connect to your
CallPilot server for troubleshooting purposes. Nortel connects to your server
only when you request technical assistance.

Required equipment

To install the modem, you need the following equipment:
an RJ-11 analog phone cord
a power adapter cord
an analog line jack
tweezers, or a screwdriver small enough to use to adjust DIP switches
The following modem is provided with your server:
an analog external U.S. Robotics 56-Kbit/s modem (NTRH9078) that
includes a 25-pin male to 9-pin female shielded serial cable for your
modem
Note: Ensure that you have the correct cable for your modem, as
follows:
56-Kbit/s modem: A0841984
1002rp Server Hardware Installation
Installing the server and connecting the peripheral devices
61