To Install The Software Feature Dongle - Nortel CallPilot 1002rp Hardware Installation Manual

Installing the server and connecting the peripheral devices
Requirements
For installation, you require a Phillips No. 1 screwdriver.

To install the software feature dongle

1 Ensure that there is no cable connected to the parallel port.
Note: The parallel port is also known as the printer port or LPT1. It is
located at the back of the server. See the diagram on page 65.
2 If the software feature key is not preinstalled in the dongle, remove it
from the plastic bag, and carefully insert it into the software feature slot
on the dongle. Make sure that the clips secure it properly and that the
Nortel logo faces outwards.
3 Plug the male end of the adapter into the parallel port.
4 Tighten the connector screws.
What's next?
Continue with "Connecting the server to power" on page 75.
74
Standard 1.07
CallPilot