Wireless Security - TP-Link TL-WR1043ND User Manual


Note:
1) The WPS LED on the router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
5.4.3

Wireless Security

Choose menu "Advanced→Wireless→Wireless Security", you can configure the security
settings of your wireless network. There are five wireless security modes supported by the
router: WPA-Personal, WPA2-Personal, WPA-Enterprise, WPA2-Enterprise, and WEP.

Disable Security - If you do not want to use wireless security, check this radio button. But
it's strongly recommended to choose one of the following modes to enable security.
 WPA/WPA2-Personal - It's the WPA/WPA2 authentication type based on pre-shared
passphrase. The router is configured by this security type by default.

Version - You can choose the version of the WPA-PSK or WPA2-PSK security on the
drop-down list. The default setting is WPA2-PSK.
TL-WR1043ND 450Mbps Wireless N Gigabit Router
-42-