Step 3: Check The Base/Expansion Power Supply Jumper Plug; Step 4: Mount The Base Cabinet - Toshiba STRATA CTX100 Installation And Maintenance Manual

Step 3: Check the Base/Expansion Power Supply Jumper Plug

The APSU112A power supply is used in both CTX100 cabinets.
➤
Check that the "BASE/EXP." jumper plug is connected to the proper power supply connector
as shown in Figure
other "EXP."
• If the power supply is mounted in the CTX100 Base Cabinet, the "BASE/EXP." jumper
plug must be plugged into the "BASE" connector.
• If the power supply is mounted in the CTX100 Expansion cabinet, the jumper plug must be
plugged into the "EXP." connector.

Step 4: Mount the Base Cabinet

WARNING! To prevent electrical shock, make sure the power supply is not plugged into
the AC outlet.
1. Make sure the location of the Base Cabinet meets the minimum clearance requirements
specified in Figure 2-1 on page
Note The Base Cabinet AC power cord is four feet, five inches long.
2. Attach a 1/2" thick plywood back board to the wall where the CTX100 will be installed. Secure
the back board to the wall with screws attached to the wall studs, shown in
3. Place the Base Cabinet back cover at the desired location on the back board using a level and
mark the location of the four screw holes (there is one on each corner).
4. Drill holes on these marks.
5. Secure the top two screws approximately two thirds of the way into the top two holes on the
back board.
6. Hang the Base Cabinet back cover from the top two screws and then secure the top and bottom
screws completely into the back board. The base back cover should now be tightly secured to
the back board. See
7. To mount the Base Cabinet, position the cabinet hanger holes onto back cover hangers (two on
top and two on the bottom as shown in
8. Secure the Base Cabinet to the back cover with a screw through the left side bracket of the back
cover to the Base Cabinet. (See Screw "A" in
9. If you are installing an Expansion Cabinet, go to
required)" on page
Strata CTX I&M 10/02
2-14. The power supply has two connectors: one is labeled "BASE" and the
2-3.
Figure 2-5.
Figure
2-9. Follow the steps, then return to these steps.
2-6). Slide the cabinet to the left.
Figure 2-5.)
"Step 5: Mount the Expansion Cabinet (if
Strata CTX100 Installation
Installing the CTX100 Cabinet
Figure 2-5.
2-7