Ctx670 Processor Pcb Subassemblies; Ctx670 License Control; Licensed Software Options - Toshiba STRATA CTX100 Installation And Maintenance Manual

CTX670 Processor PCB Subassemblies

Subassemblies can be added to the processor PCBs to enable system expansion and provide
additional features. The subassemblies are:
• BEXS and BBMS expansion PCBs mount onto the processor PCBs to provide increased port
capacity, from Basic (192 ports) to Expanded (672 ports). The BEXS provides switching
capacity, and an additional 16 DTMF receivers and 16 Busy Tone detectors. The BBMS
provides memory capacity. For Basic and Expanded capacities of stations, lines and features,
see Tables 1-3~1-7. To expand the system, both subassemblies must be installed.
• BSIS interface PCB which attaches to the BECU to provide up to four RS-232 interface ports
for SMDR Call Accounting and SMDI or Toshiba Proprietary Voice Mail interface.
See Table 1-3 on page 1-9
Expanded systems.

CTX670 License Control

The system size and feature capability is controlled using a software License Key Code. This key
code is obtained from the Toshiba Internet FYI site during the ordering process and is installed
onto the system processor via Strata CTX WinAdmin. Processor license codes activate system
hardware capacities in the following increments.
• The first 64 line/station ports do not require a license. Each additional set of four line/station
ports requires one LIC670-4PORTS license (maximum of 672 ports).
• The on-board DTMF receiver circuit provides up to 32 DTMF receiver hardware circuits. The
first four DTMF circuits do not require a license. Each additional set of four DTMF receiver
circuits requires one LIC670-4DTMF license (max. total of 32 DTMF circuits).
DTMF tone receiver circuits are required for standard telephones, Voice Mail DTMF
Note
integration, Tie, DID and DNIS line service.
• The optional RS-232 serial port interface (BSIS) provides two circuits to interface with Voice
Mail SMDI or Toshiba Proprietary Voice Mail integration, Call Accounting SMDR, and two
for future applications. The first circuit does not require a license, but circuits two through four
each require one LIC670-SER PORT license.

Licensed Software Options

Some software options are activated with license codes. The following software options require a
license:
• Each CTX system (node) in a Strata Net QSIG Network requires one LIC670-QSIG NET
license. A maximum of four serial network nodes are allowed in any one serial chain in the
network topology.
• Each individual CTI Open Architecture application requires one LIC670-CSTA AP
license (maximum nine).
Strata CTX I&M 10/02
for the number of cabinets and universal PCB slots for the Basic and
Strata CTX Configuration
CTX670 License Control
1-7