Tilt Stand For Dkt + 2 Adms - Toshiba STRATA CTX100 Installation And Maintenance Manual

Tilt Stand for DKT + 2 ADMs

Use Tilt Stand models "BTSA" for DKTs with one or two ADMs.
➤
To attach a digital telephone with two ADMs to a Tilt Stand
1. Complete the steps under
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see
4. Place the spacers on the outer holes, as shown (see
5. Attach Tilt Stand to bottom of DKT with screws.
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the "bottom
pegs" fit into the holder. Adjust Tilt Stand so that the "top pegs" fit into the top Tilt Stand Base
holes. Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees). See
Figure 8-23.
8. Push in the Lock Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt
Stand.
(A)
Spacer
1 ADM DKT
1 ADM DKT
2 ADM
2 ADM
1 ADM
1 ADM
2 ADM
2 ADM
Figure 8-22 Attach Tilt Stands to DKT with Two ADMs
Strata CTX I&M 10/02
"To install DADMs" on page
2 ADMs + 1 DKT
ADMs
DKT
DKT
1 ADM
DKT 2 ADM
Put in three screws in the
positions marked "2ADM."
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
8-20.
Figure 8-21).
Figure 8-22).
DKT
DKT
1 ADM
2 ADM DKT 1 ADM
Put in three screws in the
positions marked "DKT."
Station Apparatus
Tilt Stands and Wall Mounting
(A)
Spacer
DKT
2 ADM
5609
8-25