Rbsu/Rbss Installation - Toshiba STRATA CTX100 Installation And Maintenance Manual

TE
TE Device
Power sink
40S Power Limits:
oltage: 33.3VDC to 38.85VDC maximum
urrent: 100mA maximum (25mA maximum per each RBSU/RBSS circuit)
Figure 5-8 Power Limits of the Backup Power Supply

RBSU/RBSS Installation

Run Related Programs
Step 1:
➤
Run all ISDN programs related to RBSU/RBSS BRI circuits prior to installation of the PCBs.
This enables the circuits to operate immediately upon insertion. ISDN BRI programs are
explained in the Strata CTX Programming Manual under the ISDN tab.
Set Option Switches/Jumpers
Step 2:
➤
Set all option switches and jumpers on the RBSU and RBSS PCBs before plugging the RBSS
onto the RBSU or inserting the RBSU into the system. RBSU/RBSS switch/jumper
information and locations are shown in
Strata CTX I&M 10/02
RJ45 Pin Nos. on
RBSU or RBSS
NT circuit
Pin 3 RX +
Pin 6 RX -
Pin 4 TX +
Pin 5 TX -
RJ45 Pin Nos.
on TE device
Figures 5-9,
RBSU/RBSS Interface Units
RBSU
Pin 3
R40S PS-1
Pin 6
Power
Pin 4
Source
Pin 5
5-10 and Table 5-4.
ISDN Interfaces
4774
5-13