Pdku2 Hardware Options; Pdku2 Installation - Toshiba STRATA CTX100 Installation And Maintenance Manual

PCB Installation
PDKU2 – Digital Telephone Interface Unit
PDKU2 – Digital Telephone Interface Unit
Circuits per PCB:
Interfaces with:
Older Version(s):

PDKU2 Hardware Options

PDKU2 does not have to be configured for any option. Refer to
instructions on how to connect digital telephones, DADMs, and DDSS consoles to the PDKU2.
Refer to
Notes
• BPCI, RPCI-DI and PDIU-DI are not supported on Strata CTX.
• With the DKT3000-series telephones, limitations are 16 (not 24) character LCD display,
6SGLDO
There are no controls or indicators on the PDKU

PDKU2 Installation

1. Insert the PDKU2 (component side facing right) into the appropriate slot, and apply firm, even
pressure to ensure proper mating of connectors.
2. After installing the PDKU, gently pull the PCB outward. If the connectors are properly mated,
a slight resistance is felt.
50-Pin Female Amphenol Connector
Figure 4-6 PDKU2 PCB
4-10
eight digital telephone circuits
digital telephones (with or w/o ADM) (See Notes under Hardware Options)DDSS
console (circuit 8 only)
cordless digital telephones (DKT2004-CT, DKT2104-CT)
DKT2001 single line digital telephones
PDKU1 (identical to PDKU2 except it does not support continuous DTMF tones
w/DKT2000-series telephones, DIUs can only be connected to circuits 1~7)
Chapter 9 – Peripheral Installation
)HDWXUH
and LCD buttons don't work and the BPCI cannot be used
Chapter 8 – Station Apparatus
for instructions on connecting Door Phones (DDCBs).
(Figure 4-6).
5807
for
Backplane Connector
Strata CTX I&M 10/02