Installing The Ctx100 Cabinet; Step 1: Remove Cabinet Covers; Step 2: Remove The Back Cover From The Cabinet(S) - Toshiba STRATA CTX100 Installation And Maintenance Manual

Strata CTX100 Installation

Installing the CTX100 Cabinet

Installing the CTX100 Cabinet

Step 1: Remove Cabinet Covers

WARNING! Ensure the power supply AC plug is not
1. Loosen the screws from the front cover to remove it.
2. Loosen the four screws from the top cover and slide it off.
3. Loosen the four screws from each side cover and pull the
covers forward to remove them.

Step 2: Remove the Back Cover from the Cabinet(s)

1. Remove and save the two screws from the back of the Base Unit.
2. Slide the metal cover about a half inch to the right (it will drop down and forward) to remove it.
3. If you are installing an Expansion Cabinet, remove one screw from the back of the Expansion
Cabinet. Slide the metal cover to the right to remove it.
The figure below show the position of the screws. Back covers should be removed before
Note
the Base and Expansion cabinets are attached to each other.
Remove 1 screw
Figure 2-4 Base and Expansion Cabinet Back Covers
2-6
plugged into the AC outlet.
EXPANSION
Figure 2-3
BASE
5933
6094
Cabinet Cover
Removal
Strata CTX I&M 10/02