Toshiba Strata DK14 Programming Manual page 158

System & Station
Program 39 – Flexible Button Assignments
Program 39 Overview
Program 39 assigns features to the flexible buttons for individual telephones in the system. Several
types of buttons can be assigned with this program, including:
Feature
[PDNs], [SDNs] and [PhDNs] – Message Waiting buttons can be assigned to [PhDNs]
Alert Signal (Buzz key)
Feature Buttons Assignments
You can assign commonly used telephone features to any flexible button (see Table 3-1). Button
assignments can be different for individual telephones. Telephone users can also assign flexible
buttons if their COS and/or if programming permits the feature on their telephone.
Strata AirLink handsets interfaced to the Strata DK using the RWIU/WWIS PCB have only six
flexible buttons (4~9) available for programming.
Important!
DKAdmin programs a Pause on buttons 11~20 on 10-key telephones.
The
button. Do not program CO lines or secondary line appearances onto button 01 or in any
other position. Since the system assigns CO lines 01~17 by default, be sure to remove any CO
line appearances by programming them as Station Speed Dial buttons (code
Note If the
6HOHFW
and
To assign features to flexible buttons
1. Complete Program 38 before Program 39. Initialized data assigns the keystrip pattern
associated with Code 31 from Program 38.
2. Use
Use the programming sequence after this table to perform the following steps.
3. Program the port number or enter a range of port numbers.
4. Press the button that will be associated with the feature.
5. Enter the feature code.
6. Repeat this procedure until all feature buttons have been assigned.
Table 3-1 Feature Button Codes for Digital, Electronic, and Strata AirLink Wireless Telephones
Button Function
Account Code
1
Alarm
Alert Signaling (see following pages)
All Call Voice Page
Automatic Busy Redial
Automatic Callback Busy
1
Background Music
Call Forward All Calls
3-112
/LQH
button on the DKT2001 is flexible button 01. Only program a [PDN] onto this
6SHHG 'LDO 6HOHFW
button. While on an outside call, the user must press
DTMF tones for the duration of the call.
"Program 39 – Flexible Button Assignments"on Page 3-111
Button Labels
Account Code or ACCNT
Alarm Reset or ALRM
1
All Call Page or AC
Auto Busy Redial or ABR
Auto Callback or ACB
Tel Set Music or BGM
Call Frwd All Calls or CFAC
button is removed, the
Code
450 Allows a Voluntary Account Code entry.
477 Resets alarm condition system-wide.
489 Pages up to 120 idle electronic or digital telephones over speaker.
470 Sets ABR of busy outgoing number.
494 Sets ACB for station recalled by busy line.
478 Turns BGM ON or OFF through station speaker.
487 All calls forward to selected station.
).
6SHHG 'LDO
key becomes the
then to activate the
to indicate feature buttons.
Notes
Strata DK Programming 5/99