Table of Contents
Advertisement
WI1387 7/05
Central Station Receiver 1 Account Number
Acc #
Enter an account number of up to four digits. Use number buttons
Press the
( _ _ _ _ )
NEXT/YES button to proceed.
NOTE: Central Station Receiver 2-4 Account Numbers can only be entered in Direct Address Programming.
(Direct Entry)
See CS Reporting Options.
Central Station Receiver 1 Format
RecFmt
From the table below, enter the central station's receiver format. Use number buttons
NOTE: Press the
( )
through
(Direct Entry)
proceed.
NOTE: Central Station Receiver 2 and 3 Formats can only be entered in Direct Address Programming. See
CS Receiver Options.
Enter User Codes (Press the (
User01
For default program, enter up to 64 User Codes, with Area 1-4 Options.
Press
______
enter a code from 3 to 6 digits. Enter up to 6 digits (4 digits is recommended) in the first six boxes from
left to right for each user code. Valid entries are: 0-9. NOTE: Press
(Direct Entry)
G0
OPT__
"Enable Global Ambush Code" (Address 0720) is enabled and "Global Ambush Code" (Address 1054) is
not left blank(•), do not program the first two digits of ANY User Code the same as the "Global Ambush
Code". Note: If the programmed code was less than 6 digits, press
(Direct Entry)
Options Level (OPT). Refer to the table on the next page for the available area options. Note: Duplicate
ACC __
User Codes are not allowed; therefore a duplicate Code entered in the LCD Window will erase when
(Direct Entry)
pressed.
L
NAPCO Security Systems
buttons for a zero and press
G 0
buttons for a zero and press
G 0
for letters B–E, respectively. Press
G 4
DATA ENTRY
CS RECEIVER 1 FORMAT
•(blank)
Ademco Slow, Silent Knight Slow
2
Radionics Fast
3
Silent Knight Fast
4
Radionics, DCI, Franklin Slow
R
once to set the cursor to the User Code. Use the number buttons
R
for a blank space (•). No blank spaces in between; leave blank (•) any trailing boxes. If
1
for a blank space (•). Press
0
for a blank space (•). Press
0
U
to save. Press the NEXT/YES button to
DATA ENTRY
5
B
C
E
) button to set cursor.)
X
GEM-P1664EX Programming Instructions
Page 9
through
for digits 1–9. NOTE:
9
U
to save. Press the
through
1
9
G 1
CS RECEIVER 1 FORMAT
Universal High Speed
SIA
Ademco Point ID
Pager
through
1
9
for a zero and press
0
to set the cursor to the Area 1
R
.
to
U
is
Advertisement
Table of Contents
