Table of Contents
Advertisement
THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN
This manual supports the keypad programming of the GEM-P1664EX control panel with the NAPCO "classic" GEM-
RP2ASe2, GEM-RP3DGTL and GEM-RP4RFC series keypads as well as the GEM-K2AS, GEM-K3DGTL and GEM-
K4RF "K Series" keypads. The new "K Series" models offer the new STAY and AWAY buttons with simplified function-
ality, along with the new MENU and ENTER buttons. While the instructions in this manual are depicted using the "K Se-
ries" keypads, the manual applies to both the "classic" and the "K Series" keypads.
Program Mode is the same for both keypads--only the button names have changed, as follows:
A
• The
button and the
D
• The
button and the
• The
button and the
"NEXT/YES button" are used in this manual.
• The
button and the
"PRIOR/NO button" are used in this manual.
For consistency, it is recommended that all keypads either be all "classic" or all "K Series"--both keypad
types should not be used in one alarm system.
CONTROL PANEL FIRMWARE VERSION 01 OR LATER.
IMPORTANT NOTE
R
button operate identically (in Program Mode) for both keypads.
U
button operate identically (in Program Mode) for both keypads.
button operate identically (in Program Mode) for both keypads. The words
button operate identically (in Program Mode) for both keypads. The words
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
NAPCO Security Systems, Inc.
Advertisement
Table of Contents
