Sharp AR-M450 Service Manual page 75

5-3
Purpose Operation test, check
Function (Content) Used to check the operations of the copy lamp
and its control circuit.
Section Scanner (reading), DSPF (reading)
Item Operation
Operation/Procedure The copy lamp or CIS is lighted for 10sec and
turned off.
* CIS is displayed only when DSPF is installed.
SIMULATION 5-3
COPY LAMP TEST. SELECT 1-2, AND PRESS START.
1.COPY LAMP
2.CIS
Press [START] key to get started.
SIMULATION 5-3
COPY LAMP TEST. EXECUTING...
1.COPY LAMP
2.CIS
1
Press [CUSTOM SETTING] key to stop.
Stops after 10sec.
1
AR-M350 SIMULATIONS 10-14
Main code 6
6-1
Purpose Operation test, check
Function (Content) Used to check the operation under load
(clutches and solenoids) in the paper transport
system and their control circuits.
Section Paper transport (paper exit, switchback,
transport)
Item Operation
Operation/Procedure Select with 10 digit key pad.
SIMULATION 6-1
FEED OUTPUT CHECK. SELECT 1-17, AND PRESS START.
2.HLPR 3.DCPR
7.DSB_RV 8.CPFC 9.RRC
12.LUM 13.TRC_DSK
15.MCM 16.MCPCL 17.MCFCL 18.MCLUM
19.MPFS 20.MPFC 21.MSS
Press [START] key to get started.
SIMULATION 6-1
FEED OUTPUT CHECK. EXECUTING...
2.HLPR 3.DCPR 4.MM 5. DM 6.DSB_FW
7.DSB_RV 8.CPFC 9.RRC 10.TRC 11. FGS_FIN
12.LUM 13.TRC_DSK
15.MCM 16.MCPCL 17.MCFCL 18.MCLUM
19.MPFS 20.MPFC 21.MSS
<List of set values>
2 HLPR (Heater power relay)
3 DCPR (DC power relay)
4 MM (Main motor)
5 DM (Drum motor)
6 DSB_FW (Stepping motor forward rotation)
7 DSB_RV (Stepping motor reverse rotation)
8 CPFC (Paper feed clutch)
9 RRC (Resist roller clutch)
10 TRC (Transport roller clutch)
11 FGS_FIN (Finisher gate solenoid)
12 LUM (Tray 1 lift-up motor)
13 TRC_DSK (Desk clutch sync signal)
14 PSPS (Separation pawl solenoid)
15*1 MCM(MP drive motor control signal)
16*1 MCPCL(MP tray paper feed clutch signal)
17*1 MCFCL(MP tray transport clutch signal)
18*1 MCLUM(MP tray lift-up motor signal)
19*2 MPFS (Manual paper feed solenoid signal)
20*2 MPFC (Manual paper feed clutch signal)
21*2 MSS (Manual paper feed gate solenoid)
*1 Displayed when OPTION of multi-purpose only.
*2 Displayed when manual feed OPTION is added.
4.MM 5.DM 6.DSB_FW
10.TRC 11.FGS_FIN
14.PSPS 2
Press [CUSTOM SETTING] key to stop.
Or stops after repeating
the specified number of times.
2
14.PSPS