Sharp AR-M450 Service Manual page 65

Code
Main Sub
26 41 Used to set Enable/Disable of the magnification ratio auto
selection function (AMS) in the pamphlet copy mode.
52 Used to set Enable/Disable of count-up when white paper is
discharged. (White paper means the index paper
(without copying) in the OHP index paper insertion mode,
the front/rear covers (without copying) in the cover insertion
mode, and white paper in the duplex exit mode (CA, etc.).)
27 1 Used to set the operation specifications when a communication
trouble occurs between the host computer and MODEM
(machine side). (When a communication trouble occurs
between the host computer and MODEM (machine side), self
diag display (U7-00) is displayed and setup is made to inhibit or
allow printing. )
5 Used to enter the machine tag No. (This function allows to
check the machine tag No. from the computer.)
30 1 Used to check the operations of the sensors and detectors in
the paper feed, paper transport, and paper exit sections and
their control circuits.
2 Used to check the operations of the sensors and detectors in
the paper feed section and their control circuits.
(The operations of the sensors and detectors in the paper feed
section can be monitored on the LCD display.)
40 1 Used to check the operations of the manual paper feed tray
paper size detectors and their control circuit.
(The operations of the manual paper feed tray paper size
detectors can be monitored on the LCD display.)
2 Used to adjust the detection level of the manual paper feed tray
paper width detector.
7 Used to enter the adjustment value of the manual paper feed
tray width detection level.
11 Used to check the width detection level of the multi purpose
tray paper width detector.
12 Used to adjust the width detection level of the multi purpose
tray paper width detector.
41 1 Used to check the operations of the document size sensor and
the related circuit. (The operation of the document size sensor
can be monitored on the LCD display.)
2 Used to adjust the detection level of the document size sensor. Adjustment
3 Used to check the operations of the document size sensor and
the related circuit. (The output level of the document size
sensor can be monitored on the LCD display.)
43 1 Used to set the fusing temperature in each operation mode.
44 1 Used to set Enable/Disable of each correction operation in the
image forming (process) section.
4 Used to set the target image (reference) density level in the
developing bias voltage correction.
9 Used to check the result (main charger grid voltage developing
bias voltage, laser power, etc.) of correction
(process correction) in the image forming section.
(By this simulation, the correction operation can be checked.)
Function (Content)
AR-M350 SIMULATIONS 10-4
Purpose
Setup
Setup Paper transport
(Paper exit,
switchback, transport)
Setup Communication
(RIC/MODEM)
Setup Communication
(RIC/MODEM)
Operation test, check
Operation test, check Paper feed
Operation test, check Paper feed
Adjustment Paper feed
Adjustment, setup Paper feed
Operation test, check Paper feed
Adjustment, setup Paper feed
Operation test, check Other
Other
Operation test, check Other
Setup Fusing, paper exit
Setup Process (OPC drum,
developing, transfer,
cleaning)
Setup Process (OPC drum,
developing, transfer,
cleaning)
Adjustment, setup, Process (OPC drum,
operation data output, developing, transfer,
check (display, print) cleaning)
Section Item
Spec Operation
mode
(Common
operation)
Spec Operation
mode
(Common
operation)
Data
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Data
Data Operation
data
(machine
condition)