Simulations; Entering The Simulation Mode; Switching The Simulation Mode; Canceling The Simulation Mode - Sharp AR-M450 Service Manual

[10] SIMULATIONS

1. Entering the simulation mode

Enter the copy mode and perform the following procedures.
[P] [*] [C] [*] [Main code]

2. Switching the simulation mode

Press [USER SETTING] to return to the code entry screen.

3. Canceling the simulation mode

Press CA key to cancel the simulation mode.

4. Simulation list

Code
Main Sub
1 1 Used to check the operations of the scanner (reading) unit and
its control circuit.
2 Used to check the operations of the sensors and detectors in
the scanner (reading) unit and their control circuits.
2 1 Used to check the operations of the automatic document feeder
unit and its control circuit.
2 Used to check the operations of the sensors and detectors in
the automatic document feeder unit and their control circuits.
3 Used to check the operation under load in the automatic
document feeder unit and their control circuits.
3 2 Used to check the operations of the sensors and detectors in
the finisher and their control circuits.
3 Used to check the operation under load in the finisher and their
control circuits.
6 Used to adjust the stacking capacity of the finisher.
(Used to adjust the alignment plate (jogger) stop position in the
finisher paper width direction. The adjustment is made by
changing the alignment plate home position in the paper width
direction by software. )
10 Used to adjust the console finisher (AR-FN7).
20 Used to check the mail bin stacker (AR-MS1) sensor.
21 Used to check the operations of the mail bin stacker loads.
4 2 Used to check the operations of the sensors and detectors in
the paper feed section (desk paper feed/large capacity trays)
and their control circuits.
3 Used to check the operation under load in the paper feed
section (desk paper feed/large capacity trays) and their control
circuits.
5 1 Used to check the operations of the lamps and LCD on the
operation panel and their control circuits.
2 Used to check the operations of the heater lamp and its control
circuit.
3 Used to check the operations of the copy lamp and its control
circuit.
6 1 Used to check the operation under load (clutches and
solenoids) in the paper transport system and their control
circuits.
2 Used to check the operations of each fan motor and its control
circuit.
7 1 Used to set the aging conditions.
6 Used to set the intermittent aging cycle.
8 Used to set Enable/Disable of warm-up time display.
[START] [Sub code]
Function (Content)
AR-M350 SIMULATIONS 10-1
[START]
Purpose
Operation test, check Scanner (reading)
Operation test, check Scanner (reading)
Operation test, check DSPF
Operation test, check DSPF
Operation test, check DSPF
Operation test, check Finisher
Operation test, check Finisher
Adjustment Finisher
Adjustment Finisher
Operation test, check Mail bin stacker
Operation test, check Mail bin stacker
Operation test, check Paper feed
Operation test, check Paper feed
Operation test, check Operation
(display, operation)
Operation test, check Fusing
Operation test, check Scanner (reading)
Operation test, check Paper transport
(paper exit,
switchback, transport)
Operation test, check Others
Setup
Setup
Setup
Section Item
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation
Operation