Replacement Of Crankshaft Rear Oil Seal - Toyota 3b Repair Manual

ENGINE MECHANICAL
_
nder Block
REPLACEMENT OF CRANKSHAFT REAR OIL
SEAL
HINT:
There are
two methods (A and B)to replace the
oil
seal
as
follows.
REPLACE
CRANKSHAFT REAR OIL SEAL
A.
lf
rear
oil seal retainer is removed
from cylinder
block:
(a)
Using a
screwdriver and hammer, tap out the oil seal.
(b)
Using SST and a hammer, tap
surface is
flush with the rear oil
ssr
09223-56010
(c)
Apply MP grease to the oil
seal
in the oil seal until
seal retainer
edge.
lip.
I
lf
rear
oil
seal retainer is installed
to cylinder block:
(a)
Using a knife, cut off the oil seal lip.
(b)
Using a screwdriver, pry out the oil
seal.
NOTICE: Be careful not
to
damage
the
crankshaft,
Tape
the screwdriver.
(c)
Apply
MP
grease to a new oil
seal.
(d)
Using SST and a hammer, tap in the oil seal until
its
surface
is
flush with the rear oil seal retainer
edge.
ssr
09223-56010
j/
,
Cut
Position \
i
fi:$
*--'',,u,,(Ju