Programming Regular And Database Polling - Muratec MFX-1500 Operating Instructions Manual

Programming regular and database polling

Note: To erase a programmable one-touch key, refer to page 2.70.
Note: For database polling to work, three things must be true:
The remote fax must be a memory-equipped Muratec fax (other than an
F-76, F-85 or F-86) with a file stored in its database memory and ready
for polling.
The database file which you're polling must exist on the remote fax.
You must know the one- or two-digit file number for each database file
you wish to poll.
Note: You cannot program continuous polling into a programmable one-touch
key. For more information on continuous polling, see page 2.32.
To program a polling operation, whether regular or database, into a programmable
one-touch key:
1. Change to the Fax mode then press
either shows:
Select Program No.
73:No Number Stored
. . . or indicates a command already is programmed into this key.
If 73 is the key you want to program, skip to step 4. (However, our
examples from here will say "76" rather than "73. "
2. Select the key in which you want to program a command or change a
previously stored command — if necessary, turn the fliptab to see it, as
described earlier — and then press it. Here, we've selected 76.
Select Program No.
76:No Number Stored
3.
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4.
Press . The display now shows either:
ENTER
76:Fax Number
_
, , 1, . The display
PROGRAM C ENTER
76:Fax Number
or
9-5557312_
5. Use the numeric keypad to enter the number exactly as your machine
should dial it, including whatever codes your phone system may require.
The number can be up to 40 characters in length:
76:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters
beyond those 20 (such as with an international long-distance numbers),
press to scroll leftward or
Important: Do not press
ENTER
Note: If you make a mistake or want to erase characters entered in a
previous setting, press
CANCEL
to change just one character in the number, press
cursor leftward, or to move it rightward, to that character and
press to erase it. Then re-enter until the number is just as
CANCEL
you want it.
6. Now, while you still can see the fax number on the display, press
four times and then press
COMMUNICATION OPTIONS
The display shows:
Polling
File No. _
If you're performing regular (not database) polling, press
to step 8.
7. Use the numeric keypad to enter the one- or two-digit identifier for each
database file you want to poll. You can specify up to 10 files; between the
entry of each new file, press
COMMUNICATION OPTIONS
but do not insert a comma after the last file number.
For example, here, we've entered 2, 6,
, 2, 8,
COMMUNICATION OPTIONS
preparation for another file number):
Polling
File No. 6,27,28_
Note: The display shows only seven characters of the file number.
Important: Again, do not insert a comma after the last file number.
When the entry is complete, press
8. If you want the polling to begin immediately every time you press the key,
press again and skip to step 11.
ENTER
If you want to delay the polling (perhaps to take advantage of lower phone
rates), press
COMMUNICATION OPTIONS
Beyond the bas cs
to scroll rightward.
.
to erase leftward. Or, if you want
to move the
.
ENTER
and skip
ENTER
to insert a comma
, 2, 7,
COMMUNICATION OPTIONS
(the letter in
COMMUNICATION OPTIONS
.
ENTER
, .
ENTER
2.65