Muratec F-100 Operating Instructions Manual page 97

Just in case ...
Transmission errors
.1.1 The remote fax machine didn't respond to your machine. Call someone at the
T
remote machine.
.1.4 Someone pressed
T STOP
(the very first part of the fax communication, when the two units "agree" on
the settings they'll share).
.2.1 Either the phone line disconnected during transmission or fax communica-
T
tion became impossible due to bad phone line conditions. Re-try the call.
.2.2 The two fax machines were incompatible. Your fax machine sends and
T
receives only - Group 3 (see "Glossary," page 3.17) fax communication,
ITU T
the industry standard since the early 1980s.
.2.3 Bad phone line conditions made fax communication impossible. Conditions
T
can change rapidly, so re-try the call later.
.3.2 The fax machine didn't detect the silence indicating the call had ended.
T
.4.2 After transmission began, poor line conditions developed. Re-try the call.
T
.4.4 Poor line conditions prevented transmission. Re-try the call.
T
.5.1, transmission failed (perhaps due to line noise). Conditions can change
T ECM
.5.2, rapidly, so re-try the call later.
T
.5.3
T
.8.1 A compatibility error occurred. (F-150 only.)
T
.8.10 Line noise or other problems prevented line probing. (F-150 only.)
T
.8.11 The remote fax machine didn't complete the equalizer training phase.
T
(F-150 only.)
3.10
at the remote unit in the middle of the handshake
"Check Message" printouts
When a fax call goes awry and your machine detects an error, it produces an error
printout headed by the words "Check Message." This printout lists the following
information about the transmission:
• The resulting error code
• A communications error message (see "What error messages can mean," below)
• The phone number (or, perhaps,
machine had attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here's a brief summary:
Error message
Check condition of
remote fax
Repeat transmission
Line is busy
Check received documents
Memory full
Dialing number is not set
Stopped
) of the fax machine with which your
TTI
Possible meanings
• Remote machine malfunctioned
• No "handshake" signals from remote fax
• Wrong phone number reached
• Poor phone line conditions
• No "handshake" signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after
attempting specified number of redial tries
• Remote machine's line was busy
• Remote machine's line didn't answer
• Remote confirmation signal not received
from remote fax
• Poor line conditions caused a poor image
• Remote fax's memory capacity exceeded
• Stored phone number failed to dial properly
• Someone pressed at the remote fax
STOP
in the middle of the "handshake"