Muratec F-100 Operating Instructions Manual page 68

To program a SecureMail transmission into a programmable one-touch key:
1
Press / , , 1,
PROGRAM C ENTER
Select Program No.
... or indicates a command already is programmed into this key.
If 01 is the key you want to program, skip to step 3. (However, our examples
P
from here will say " 11" rather than "
P
2
Select the key in which you want to program a command or change a previ-
ously stored command — if necessary, turn the fliptab to see it, as described
earlier — and then press it. Here, we've selected
Select Program No.
3
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press . The now shows either
ENTER LCD
P11:Fax Number
_
5
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The num-
ber can be up to 40 characters in length:
P11: Fax Number
9-5558422_
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
scroll leftward or /
PROGRAM
Important: Do not press
ENTER
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press
CANCEL
just one character in the number, press
or / to move it rightward, to that character. Then re-enter
PROGRAM
until the number is just as you want it.
. The either shows:
LCD
01.")
P
11.
P
P11:Fax Number
or
9-5552208_
to scroll rightward.
.
to erase leftward. Or, if you want to change
to move the cursor leftward,
6
Now, while you still can see the fax number on the
COMMUNICATION OPTIONS
S Mail Tx
S Mail No.
7
Use the numeric keypad to enter the appropriate one-digit SecureMail mail-
box number. In this example, the number is 5.
S Mail Tx
When finished, press
8
If you want the transmission to begin immediately every time you press the
key, press
ENTER
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
9
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
to
10
Press ,
ENTER ENTER
11
The now displays the next programmable one-touch key.
LCD
If you do not wish to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do wish to enter or change this key's programming, go back to step 3.
If you wish to enter or change another key's programming, go back to step 2.
LCD
two times and then press
_
.
ENTER
and skip to step 11.
,
COMMUNICATION OPTIONS ENTER
Delayed
PM
Delayed
.
Beyond the basics
, press
. The shows:
ENTER LCD
.
on the 30th.")
PM
today.")
STOP
2.39