Muratec F-100 Operating Instructions Manual page 95

Just in case ...
What you see on the
LCD
Check Paper Size
Check Rx Paper
Check Tray Paper
Check Cassette Paper
Too Many Locations
Scanner In Use
Feeder In Use
Printer In Use
Polling In Use
Document Stored
Invalid Passcode
3.8
What it means/What to do
The multipurpose tray's paper size setting (see
page 1.8) doesn't conform to the paper actually
in the tray. Either change the setting or change
the paper so that each is the same as the other.
Both the multipurpose tray and paper cassette
are out of paper. Add paper to the tray and/or
the cassette.
The multipurpose tray is out of paper. Add
paper to the tray.
The paper cassette is out of paper. Add paper to
the cassette.
. . . or . . .
The paper cassette is open. Close it.
You tried to enter too many numbers for a
broadcast. You can enter up to 10 one-touch or
speed-dial numbers and numbers entered
through the numeric keypad. Press
delete the extra numbers and try again.
The command you're trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then try again.
The command you're trying to enter requires the
use of the feeder, which is already in use. Wait for
the fax to stop using the feeder, then try again.
The command you're trying to enter requires the
use of the printer, which is already in use. Wait
for the fax to finish printing, then try again.
You tried to store the polling document in your
fax, where one already had been stored. Wait
for the fax to complete the polling operation, then
try again.
You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protec-
tion passcode.
What you see on the
No Passcode
No PIN Number
No Dept. Code
Protect Doc. Stored
to
CANCEL
Please Call Service
What it means/What to do
LCD
You tried to protect an operation or department
code but there's no protection passcode stored in
your fax machine. Store a protection passcode in
your machine, then re-try protecting the opera-
tion or department code.
You selected "Mode1" in the
and tried to call an autodialer number in
which no has been entered. Enter a
PIN
try again.
You tried to turn on the department code setting
but there are no department codes stored in
your fax machine. Store at least one department
code, then try again.
A received document was in your fax's memory
when you tried to turn off security reception or
erase the protection passcode. Print the received
document from your fax's memory, then re-try
the desired operation.
The printer unit of your machine has become
inoperable. Call your authorized Muratec dealer
or Muratec Customer Support.
mask feature
PIN
, then
PIN