Video Cable; Control Cable; Alarm Cable; Initial Setup - EverFocus EPTZ1000 User Manual

Note: The input AC voltage range of an adapter depends on different area.
Please make sure the voltage range before installing.

Video Cable

A BNC cable is used for connecting a speed dome to a DVR or a monitor. An amplifier
may be needed if the video cable is too long.

Control Cable

Basically, Outdoor/Indoor Speed Dome uses a differential pair to connect to other
devices by cascading. A cable that has low signal decline can be used as a control cable.

Alarm Cable

An alarm cable is not included in the packing list. A suitable wire can be used as an
alarm cable.

2.3. Initial Setup

Initial setup includes dome address, communication protocol, transmission speed,
video format, and terminator resistance settings. All of the settings should be confirmed
before the dome is installed. The control-related setting that is address, communication
protocol and transmission speed have to be set consistently with the control device such
as a keyboard or a DVR.
Notice: Please make sure the power is off before setting, and restart the speed dome to
enable a new value after changing.
2-14