EverFocus EPTZ1000 User Manual page 23

2. Thread the cable through the hole in the wall mount bracket, and screw in 4 M8
nuts for mounting the bracket.
3. Take off the housing from the packing, and take off the base board (4 bolts on it.)
inside the housing. Thread the cable through the top of the housing. Fix the
housing on the wall mount bracket, and screw in 3 M5 bolts (Hex) on the top of the
bracket with the attached Hex Allen wrench to fix the housing.
4. Connect the cable connectors to the nodes on the base board, and then fix the
base board in the housing by screwing 4 bolts on it.
Notice: Please notice the polarity of control line. The outdoor speed dome will not work if
the polarity of control line is mis-connected.
5. Align the two screw holes on the bottom of mechanical part to the two bolts on the
M5 Bolt
RELAY
Video +
Video -
RS485 +
RS485 -
AC24
AC24
JP3
2-22
Hex Allen wrench
JP5
JP1
JP4
JP6