Base Board - EverFocus EPTZ1000 User Manual

1.3.2. Base Board

The base board that is on the bottom of the housing connects to power cable, video
cable, control cable, alarm cable, fan and heater (fan and heater are for Outdoor Speed
Dome only). In order to connect to cables, the board needs to be taken off, and put back
after finishing connecting to all cables. The connectors of cable names are marked on the
board in white text. The details of the alarm connector (JP5) are shown on the APPENDIX
A.
For Outdoor Speed Dome, JP1, JP3 and JP6 that are two-pin connectors on the base
board need to be taken off during installation. JP1 and JP3 are connectors for heater, and
they can be switched. JP6 is a fan controller connector that turns on/off of the fan. The 3
cables are too short to be connected to a wrong connector when putting them back.
RELAY
JP5
Video +
Video -
RS485 +
RS485 -
AC24
AC24
JP3 JP1
Outdoor Speed Dome Base board
JP4
JP6
1-9