Diesel Engines; Engine Identification Numbers; Cutting Head Serial Numbers - Ransomes G-Plex II Safety And Operation Manual

GB
IDENTIFICATION
THESE IDENTIFICATION NUMBERS MUST
APPEAR ON ALL CORRESPONDENCE
CONCERNING THIS UNIT.
MODEL NUMBER & SERIAL NUMBER
Both the Model Number and Serial Number are on
the identification nameplate decal located on the
right rear frame. See figure 1.
1
Figure 1
1. Identification Nameplate Decal

ENGINE IDENTIFICATION NUMBERS

To gain access to the engine, loosen the two hand
knobs above the rear fork.Raise the fuel tank frame
(rear section) and pivot the rod beneath the fuel
tank down and secure it in the cup next to the fork
(See Fig. 2). DO NOT remove fuel tank cap while
tank is in raised position.
1
Figure 2
Fuel Tank in Raised Position
1. Support Rod
2. Hand Knobs

DIESEL ENGINES

The diesel engine's serial number is stamped into
the block directly below the injector pump (See Fig.
4).

CUTTING HEAD SERIAL NUMBERS

Identification numbers for each individual cutting
head are on the nameplate decal located on the
right side panel (See Fig. 5).
2
RANSOMES G PLEX II Series :WD
SAFETY AND OPERATORS MANUAL
1
Figure 4
1. Diesel Engine Serial Number
NAME PLATE
DECAL
Figure 5
1. Cutting Head Nameplate Decal
GB-3