Starting Remote Installation Using A Pxe Server - Fujitsu Primergy RX100 S2 User Manual

Chapter 3 OS Installation Using ServerStart

3.4.5 Starting Remote Installation Using a PXE Server

Perform remote installation using a PXE server in the following procedures.
Checking the Network Startup (PXE) Setting
Checking the MAC Address
Creating a Configuration File
(Setting of remote installation)
Starting remote Installation
■ Checking the Network Startup (PXE) Setting
Remote installation using a PXE server is performed via the onboard LAN. Enable the network startup
(PXE) of the target server.
For more details on network startup, refer to "2.1.2 Hardware Settings" ( pg.41).
■ Checking the MAC Address of the Onboard LAN
In remote installation, target servers are identified according to the MAC address. MAC addresses are
unique information to LAN cards. Check it for each target server. Check and write down the MAC
address of the onboard LAN on each target server. For details on how to check the MAC address of an
onboard LAN, refer to "2.1.2 Hardware Settings" ( pg.41).
■ Creating a Configuration File
You can create a configuration file on a client computer before starting installation. For the procedure,
refer to "3.2.1 Starting Up the Preconfiguration Mode" ( pg.71) and "3.2.2 Configure Settings in
Wizards" ( pg.74).
When creating a configuration file on the PXE server, start installation.
Specify the shared name prepared instead of the local CD-ROM as installation information.
■ Starting Installation
1
On the PXE server, start up ServerStart.
If ServerStart has already been started, you do not have to restart it.
If it is not started, click [Start]
The [Welcome to ServerStart] window appears.
96
→ →
[Programs] [Fujitsu ServerStart]
→
[ServerStart].