Fujitsu Primergy RX100 S2 User Manual page 246

Chapter 9 Operation and Maintenance
When only the user or administrator password is set, the same setting items are accessible to both
users and administrators.
When both passwords are set, users can set dates and user passwords only.
■ Changing/Deleting a Password
Set Setup(System) Password
Enter Current Password
Enter New Password
Confirm New Password
1
Enter the current password in the [Enter Current Password] field in the
password entry window.
2
Enter a new password in the [Enter New Password] field.
To delete the password, enter nothing and perform Step 4.
3
In the [Confirm New Password] field, enter the password you have entered in
Step 2.
To delete the password, enter nothing and perform Step 4.
4
Press the [Enter] key.
When you delete the password, [System Password] or [Setup Password] on the [Security] menu
shows [Not installed].
The system shuts down after three invalid password entries. If this happens, power off the server, turn
it back on, and then enter the correct password.
If you forget your password and cannot start the server, change the jumper pin setting on the
baseboard to clear the CMOS and delete the password. After the CMOS has been cleared, return the
BIOS Setup Utility to the original setting. Then, return the jumper pins to the original setting, and set
the password using the utility.
"8.1 Jumper Pin Settings" (pg.190)
246
[ ]
[ ]
[ ]