Local Address Setting; Jumbo Frame - Fujitsu Primergy RX100 S2 User Manual

Chapter 5 Operations after OS Installation

5.6.5 Local Address Setting

Specify a local address according to the following procedures.
1
Start up "Intel
used.
For Windows Server 2003
1. Click [Start] → [Control Panel] → [Intel(R) PROSet].
For Windows 2000 Server
1. Click [Start] → [Settings] → [Control Panel].
The [Control Panel] window appears.
2. Start up "Intel(R) PROSet".
2
Select a LAN card to set the local address and click the [Advanced] tab.
3
Specify a local address in [Locally Managed Address].

5.6.6 Jumbo Frame

1000BASE-T/1000BASE-SX supports Jumbo frame. When using Jumbo frame, construct the Jumbo
frame network using only devices that support Jumbo frame and apply the settings that will enable
Jumbo frame.
Configure setting for Jumbo frame according to the following procedures.
1
Start up "Intel(R) PROSet" from [Control Panel].
2
Select a LAN card to perform configuration and click the [Advanced] tab.
3
Specify the maximum frame size in the [Jumbo Frame] tab.
■ Other Cautions
You cannot connect devices directly with a cross cable without connecting a hub switch or router in
between.
154
®
PROSet". The procedure differs depending on the OS being