Fujitsu Primergy RX100 S2 User Manual page 181

■ SCSI-ID Setting of Internal Hard Disk Unit
The internal hard disk unit does not support hot-swapping. As the SCSI-ID is not set automatically, you
must set it up in advance by referring to the followings.
●
Jumper Pin Locations of the Internal Hard Disk Unit
Set the SCSI-ID of the hard disk unit using the jumper pins on the rear side of the hard disk.
[Rear side of the hard disk]
●
SCSI-ID Setting
Set the jumper pins as follows, according to the bay locations.
table: SCSI-ID Set Value for Each Bay Location
Bay 1
SCSI-ID = 0
2 4 6
1 3 5
Jumper pin setting (set at the time of purchase)
2 4 6 8 10 12 14
1 3 5 7 9 11 13
Short
Bay 2
SCSI-ID = 1
2 4 6
1 3 5
PRIMERGY RX100 S2 User's Guide
16 18 20 22 24
15 17 19 21 23
7
181